Complex “SvetL” reload procedure (second generation)

6. Turn the Complex ON using the on/off slider on the back side (a RED mark will appear on the slider when it is ON). 7. Re-enter the “SvetL” Program (Main screen). 8. Click LOAD CONTROL. If the LOAD CONTROL Section is empty – go back to the Main Screen. If there are any programs/positions left – repeat steps 1–7. 9. The load intensity Adjustment Dial must be on “100.|” Enter the previously recorded positions to the Complex in accordance with the “User's Instructions”. Positions can be changed at your discretion or as Recommended. 10. Exit the | “SvetL” Program. 11. Turn the Complex OFF using the on/off slider. You do not need to disconnect the cable from the computer. 12. Wait at least 10 minutes. 13. After 10 minutes, turn on the “SvetL” Complex ON using the on/off slider. Verify all positions in the LOAD CONTROL section and go to the main screen. 14. Exit the “SvetL” Program and disconnect the cable from the computer. 15. Now set the load intensity Adjustment Dial to the appropriate (comfortable) for you level. Intensity level can be increased by no more than 10 units once every 10 days of stable comfortable state of your body. 16. Then proceed in accordance with your usual usage of the Complex “SvetL.” Further Clarification of the Complex “SvetL” reload procedureby Feodor Shkrudnev I would very much not like someone to distort what is written by me, especially regarding the Technology. There are things, which should be basic. The second-generation “SvetL” Complex does